Ezee quando User Manual download pdf (Page 20)

Maintenance

Repairing a punctured tyre If you have a punctured tyre, we

recommend that you get a specialist to carry out the repairs. You

can always of course consult a specialist and carry out the repairs

on your own.

As the rear wheel contains the hub motor, there are additional

steps in the case you require the entire wheel to be removed from

the bike. Located on the underside of the bike, unplug the wires

than run from the motor to controller. There should be 1 x 6 pin

connection and 3 colour coded wire connections (Blue, Yellow,

Green). Unplug these before proceeding to remove the front wheel.

Be mindful of the tightening assembly sequence of washers, nuts

and spacers.

Hub motor and general inspection

After 5,000 kms (3,000 miles) of cycling. We recommend you

arrange to have a thorough inspection of your bicycle by an eZee

dealer. This includes opening up the hub motor to inspect and

lubricate the gears.

Electronic self-diagnostic system

When the bicycle is functioning normally, the red LED that is

situated by the controller is lit continually.

In the case of an electronic malfunction, the controller comes

programmed with diagnostic capabilities to determine where the

fault lies. The red LED will emit a series of blinks, count them and

refer to the table below for its explanation and solutions.

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

Ezee quando User Manual Page 20